Problems simulating C code generated by flowcode 9
Posted: Fri May 20, 2022 7:56 pm
Hello everybody. I'm having some difficulties doing simulations with Arduino, specifically on the "Tinkercad" and "wokwi" sites. I already used the C code generated by flowcode 9 in the Arduino IDE, it works normally. But when I use the C code on the sites mentioned, it doesn't work. I noticed that a directory is used that is in "C:\ProgramData\MatrixTSL\FlowcodeV9\CAL\includes.c". Is there any way to load this directory to the site and try to do the simulation?