ESP Toolchain won't install
Posted: Sun Nov 19, 2023 10:02 pm
I am getting errors when I try to install the ESP32 toolchain in FC10.
I purchased the ESP32 license and downloaded esp-idf-tools-setup-2.3.exe from the Flowcode site.
I already had Python and Git installed without error.
However, it fails on the installation of the Esp IDF with the message "Installation has failed with exit code 1"
I have done a bunch of searching and I have turned off my virus and firewall protection, did a registry clean, etc.
I was able to finish the ESP installation v5.1.1 using the offline installation package from Espressif, but Flowcode would not recognize the installation, so I went back and tried it with the esp-idf-tools-setup-2.3.exe and keep getting the "exit code 1"
I attached my log file from the most recent failed installation attempt.
I purchased the ESP32 license and downloaded esp-idf-tools-setup-2.3.exe from the Flowcode site.
I already had Python and Git installed without error.
However, it fails on the installation of the Esp IDF with the message "Installation has failed with exit code 1"
I have done a bunch of searching and I have turned off my virus and firewall protection, did a registry clean, etc.
I was able to finish the ESP installation v5.1.1 using the offline installation package from Espressif, but Flowcode would not recognize the installation, so I went back and tried it with the esp-idf-tools-setup-2.3.exe and keep getting the "exit code 1"
I attached my log file from the most recent failed installation attempt.