Flowcode Support Board

I am new to Flowcode and having followed an online tutorial I have built a very simple test project.
When I try to compile it to the target Arduino Nano I get a message stating "You do not have a valid license to perform this action". I have tried all the functions I can find in the HELP tab under licensing, but cannot see a solution.
Any help would be appreciated

Hi

What "nano" are you trying to use?

Regards

Hello.
If you have not purchased any chip packs, then the only hardware that will work is listed here

It was Nano 328 115200, but I have changed it to Nano 328.
It now compiles, but with the following error.
C:\ProgramData\MatrixTSL\FlowcodeV10\FCD\AVR\batchfiles\avrc_arduinoA.bat reported error code 0x1
I'm not sure what this means though

Hello.
Can you select Full Editor & Preview, below the reply window, Select attachments and upload the .fcfx, .msg.txt and .c files within the project folder.
Without seeing those files we can only guess.

Do you have the nano drivers installed and selected the correct comport (bottom righthand side) from within Build > Project Options...

Hello Martin,
I do not understand the first question you asked re Full Editor etc. I cannot see this on the forum page
Second question.Nano responds to Arduino IDE upload, so Drivers and Port should be ok, I think

Full editor and preview refers to the marked button in the picture below.
Once you select it you can use “Attachments” below the text box to add the requested files.

files attached

Hi

Sorry to be brief.

Your chart compiles OK for me. Did you download the toolchain / drivers from the Flowcode page?

https://www.flowcode.co.uk/download/

Regards

You are missing the .msg.txt file
That would be a big help for us if you had downloaded the AVR/Arduino toolchaain