Flowcode Support Board

Hello.

I have a question.

I'm working on a project using PIC24FJ512GA606.
When I select the project option and compile and download it, an error that the device is not recognized appears.

And when I look at the project options again, I see the other chip selected. How to solve it?


Please help.

thank you.

Looking at the PLL Block for the chip, max system CLK is 32MHz.

You need to lookup the datasheet to see what Configuration Bits and necessary registers to set.

Thank you for answer.
But the key is that the compiled data is not downloaded to the mcu.

The PICkit detects an DSPIC33FJ32MC302, so either you are using the wrong chip or you need to check your hardware setup.

By the way, next time you post compiler output please go to the ….msg.txt file in your flowchart folder and copy-and-paste the text in the file, not a screenshot for easier reading for us.

I post the message file.

What is your hardware? What is connected to what?

I'm connected PICKIT3 to PIC24FJ512GA606.

A bit more information would not hurt. How did you connect the two? Which pin to which pin? What else is connected?

Post my drawings.

MPLAB IPE downloads normally.
Please make it work in FC9.