FireBeetle ESP32-E GDI (General Display Interface)

[stefan.erni]

Hi Ben

dfrobot has a nice ESP32 Board. It's easy to program with FC9.
https://wiki.dfrobot.com/FireBeetle_Boa ... KU_DFR0654

On board there is a GDI connector for display present.

Are this GDI already supported by Flowcode?

Can I use some of this Display?

1. 1.54inch 240x240 IPS TFT LCD Display with MicroSD Card Breakout https://www.dfrobot.com/product-2072.html

2. 2.0inch 0x240 IPS TFT LCD Display with MicroSD Card Breakout https://www.dfrobot.com/product-2071.html

3. 2.8inch 320x240 IPS TFT LCD Touchscreen with MicroSD https://www.dfrobot.com/product-2106.html

4. 3.5inch 480x320 TFT LCD Capacitive Touchscreen https://www.dfrobot.com/product-2107.html

regards

Stefan

GDI_2022-01-04_16-39-33.png (292.69 KiB) Viewed 1815 times

[medelec35]

Hi.
It looks like the 3.5in uses a ILI9488 driver and the other gLCD's uses ST7789V
Flowcode does support those chips, so hopefully, they will work.

[stefan.erni]

Hi Martin

Thanks a lot Martin. That sounds really good. So I can use any of these displays. I'll order one and post the program later.
What I like about these displays is the connection with a very small 18-pin flat cable or with the normal "dupont" cable.

regards

Stefan