Servo Component with ESP32
Posted: Wed Nov 30, 2022 5:17 pm
Hello Ben,
I´m using the Servo Controller at a ESP32 controller. In general I have a question.
If I sent a servo set value of 32767 in 16Bit or 127 in 8Bit I would expect a servo center position of 1.5ms. In real controller life I´ll get
around 1.3ms. Unfortunately this ends up in a asymmetrical servo end positions too.
Servo Controller was set to 1ms and 2ms.
Below a scope picture, please watch for the red trace and the meas values:
Any chance to correct this situation?
BR
Dirk
I´m using the Servo Controller at a ESP32 controller. In general I have a question.
If I sent a servo set value of 32767 in 16Bit or 127 in 8Bit I would expect a servo center position of 1.5ms. In real controller life I´ll get
around 1.3ms. Unfortunately this ends up in a asymmetrical servo end positions too.
Servo Controller was set to 1ms and 2ms.
Below a scope picture, please watch for the red trace and the meas values:
Any chance to correct this situation?
BR
Dirk