Flowcode Support Board

After several months fired up FC10 again to tackle a new project.
When trying to select a processor, all except a very few are marked with a red exclamation point 'simulation only', see attached.
I refreshed my license and restarted but same issue.
Also I cannot connect an ADC to the chip, all chip pins are grayed out and are unresponsive.
What's going on??

Jan

Hi Jan.
I'm currently looking into this for you.
I will send you a pm.

Thanks Martin. I've been away last week, just tried it again, no change.

Edit: just saw your PM.
Will follow up.

Jan