Page 1 of 1
quadrature rotary encoder
Posted: Thu Jun 03, 2021 9:00 pm
by Sundwell
Hi Flowcode staff.
In Flowcode 9 the quadrature rotary encoder component is in the wrong component list.
It is located in Mechatronics, but should be located in Basic I / O
Regards
Henrik
Re: quadrature rotary encoder
Posted: Mon Jun 07, 2021 11:37 am
by BenR
Hello Henrik,
Please be aware that the licensing of component packs doesn't nessisarily correspond with the listing in the component toolbar. We do this where possible but in some cases it's simpler not to.
Re: quadrature rotary encoder
Posted: Tue Jun 22, 2021 9:57 am
by Sundwell
The problem is that I now no longer have the license for the encoder component.
If I go to your website to buy it, it is below the basic I / O that I have bought.
best regards Henrik
Re: quadrature rotary encoder
Posted: Sun Dec 05, 2021 5:56 pm
by zoli2496
I bought the Basic IO module, I can't use the Quadrature Encoder in it. And he's on the list. Why can't I use it? Why is "QuadEnc" listed on the Basic IO website?
I'm looking for a solution, thank you.
Re: quadrature rotary encoder
Posted: Sun Dec 05, 2021 9:27 pm
by medelec35
Hi zoli2496.
Thank you for the spot.
The basic IO showing quadrature encoder is a mistake.
The first image showing quadrature encoder within Mechatronics is correct.
All the components within the first image will be correct as it is now auto-generated.
This issue will be looked into and corrected.