Orthographic View Option not being saved
Posted: Thu Sep 16, 2021 5:48 pm
Hi there,
In the 3D System Panel, General Options, if you tick the Orthographic View option, after re-opening the FC file, the option although set, is not active.
Steps to reproduce:
-Create a new FC file
-Open 3D System Panel
-Change settings under General Options, tick Orthographic View.
-Save FC file
-Reload file
-Note Orthographic View option is ticked already, but the view is not orthographic (tested by panning onto the 3D Panel).
Cheers,
R
In the 3D System Panel, General Options, if you tick the Orthographic View option, after re-opening the FC file, the option although set, is not active.
Steps to reproduce:
-Create a new FC file
-Open 3D System Panel
-Change settings under General Options, tick Orthographic View.
-Save FC file
-Reload file
-Note Orthographic View option is ticked already, but the view is not orthographic (tested by panning onto the 3D Panel).
Cheers,
R