Flowcode Support Board

Hi Jorgen

Just curious, what accuracy were you getting and at what range?

Regards

Did not test that, only see that it work and the value is changing by moving my hand in front of the sensor. Just close all down Made a new test tomorrow and you hear

Hi

No need to go to any trouble, I was just curious that's all.

I my tests I found that the percentage error was pretty consistent but within groups of ranges. By that I mean that between range a-b it would be x%, range c-d would be y% and so forth.

I could not reach anywhere near two metres though.

Regards

Could you send a VL53L0X photo? Let me see if the Sensor model are the same? Thank you very much!

Send some picture tomorrow, not home at the moment

I am went home So hereby the picture, both working, but I have not testet the distance and accuracy.

Just went home Hereby a picture, both working in FC10 I have not tested the accuracy or distance. but Chipfreyer has. Hope it help.

Jorgen

Could you send me the database RangeTOF_VL53L0X.fcpx? thank you.

Hi

If you mean what my results were, I have already posted them in the forum.

Do a search for VL53L0X and you will find tbem.

Regards

My database of RangeTOF_VL53L0X.fcpx might be mistakes.Could you send yours database of RangeTOF_VL53L0X.fcpx to me.Thank you very much.