Page 1 of 1
Invert outs in standart components
Posted: Sun Nov 05, 2023 5:22 pm
by user2006
I am reprogramming finished device, so i can not change scheme, to control led display i use component from library Displays: 7segment(single) he use low and high for in and out. But me need both low for in and out
Re: Invert outs in standart components
Posted: Mon Nov 06, 2023 8:27 am
by medelec35
Hello.
Can you attach your project.
Selecting common low and common anode should work as the segments will be low to enable.
Re: Invert outs in standart components
Posted: Mon Nov 06, 2023 9:05 am
by user2006
medelec35 wrote: ↑Mon Nov 06, 2023 8:27 am
Hello.
Can you attach your project.
Hello =)
Re: Invert outs in standart components
Posted: Mon Nov 06, 2023 9:42 am
by medelec35
What version of Flowcode are you using?
Re: Invert outs in standart components
Posted: Mon Nov 06, 2023 9:46 am
by user2006
8
Re: Invert outs in standart components
Posted: Mon Nov 06, 2023 9:53 am
by medelec35
Sorry, we can't help you on these forums as they are for Flowcode v9 and v10 only.
You will need to post on
these forums.
Have you thought about upgrading to version 10 as all the components are now
free.
There are some free devices as well!
You can download v10 from
here
Re: Invert outs in standart components
Posted: Mon Nov 06, 2023 11:13 am
by user2006
medelec35 wrote: ↑Mon Nov 06, 2023 9:53 am
Sorry, we can't help you on these forums as they are for Flowcode v9 and v10 only.
You will need to post on
these forums.
Medelec however thx a lot =D I found your solution
there with swich off common pin and adding Output pin control =D
Now all work, thanks a lot again =D