Flowcode Support Board

Hello,

I received an update for the HCSR04 sensor, but from that update the sensor sends a reading of 0, I am using the PIC16F1847, I tested the sensor with another program and if it works, I think there is something wrong with the update of the file component HCSR04.

Enrique
Thanks

Hello.
Have you got the Use Timer interrupt to yes and set the timer for timer 0 and pre and post scaler both at 1:1?

I tested it using a PIC16f887 and it worked

I tested it using a PIC16f819 and PIC16f1847 and it not worked
( Use Timer interrupt to yes and set the timer for timer 0 and pre and post scaler both at 1:1 )

I can connecting echo B6 and trigger B7, timmer0 1:1 1:1 work ? or B0 and B1

Have you tried the one second flasher test to check your target device is running at the correct speed?

Hi Martin;

Yes, in fact it is working with a program that you made in Flowcode 5, but the process is simpler in flowcode 10; use the same PCBs in the process you designed in V5 if it works; Even a few months ago you fixed that component in V10, it only multiplied the reading by 1.65 and the distance was almost exact.
The problem restarted. with an update from a few days ago; now the reading is 0 zero, in V10. For now I am preferably using PIC16F1847 and PIC16F819, I did a test in V10 with the PIC16F887 and if I perform the measurements correctly.

Hello Martin,

I sent the readings with a file from the sensor that you designed in flowcode 5 with its reading and physical measurement and included the measurement with the flowcode 10 component on display and physically as well as the configuration. I use the PIC16F1847 or the PIC16F819, I send the readings using RF NRF24L01.
I have sent the data in BYTE, STRING, FLOAT, but in all cases the data sent is 0 zero.

Enrique

the rest of the photographs

Hi Enrique!

I see on your picture you use the waterproff device. For this you have to choose the AJ-SR04M type in properties and you have to play with the
Timer, Prescaler and Postscaler, maybe this could help you

Br Jorgen