Flowcode Support Board

Hello,
I want to use the STM32F030C8 and I noticed that I can only use I2C 1 - I can't use I2C 2. I was looking at the config file 32F030C8.fcdx but I couldn't figure out all the parameters to add I2C 2.
Please help!
If there is help somewhere for what all the parameters in the configuration files are for, that would be great.
Thank you!

Try the attached updated file, goes into ...
C:\ProgramData\MatrixTSL\FlowcodeV10\FCD\ARM

Thank you!
PF6 and PF7 for I2C 2 is not included - is there a reason?

I probably didn't get down as far as port F on the datasheet

Try this