ADS1115
Posted: Thu Sep 18, 2025 2:14 pm
Hi to All
The ADS1115 is working fine in "single" input mode.
Also the device addresses and the gain-set is perfect.
It is easy to use, for example, four ADS115s on an I2C bus.
There are small problems
Can this be improved?
If the alert pin is not connected, a message appears befor compile.
Setting samples per second.
A positiong is missing. The 32 per second.
I wanted to look in the component source code, but it is not available.
The ADS1115 is working fine in "single" input mode.
Also the device addresses and the gain-set is perfect.
It is easy to use, for example, four ADS115s on an I2C bus.
There are small problems
Can this be improved?
If the alert pin is not connected, a message appears befor compile.
Setting samples per second.
A positiong is missing. The 32 per second.
I wanted to look in the component source code, but it is not available.
- 2025-09-18_14-32-29.PNG (51.52 KiB) Viewed 133 times
- 2025-09-18_14-34-13.PNG (104.1 KiB) Viewed 133 times
- 2025-09-18_15-02-46.PNG (41.7 KiB) Viewed 133 times
- 2025-09-18_14-45-58.PNG (16.02 KiB) Viewed 133 times