AS5600!
Posted: Sat Sep 20, 2025 3:09 pm
Hi all!
It´s a while I last used this component so a need a test.
I am trying to make a project where I need some kind servomotor, for an automatic gate opener. So I have bougth a couble of AS5600 hall angle sensor and will first test these device with FC.
After make a test setup and managed to fix the small magnet on a shaft and center the PCB over the hall sensor ( have to be stabil and close ) I try create a testprogram, yes it work so nice with FC10 as well in debug as in realworld
I try to change the in the Properties for analog and PWM out, can change it, perfect.
I also try to change the Slow and fast filter and Hysteres, but I don´t see or feel any change, Properly me
Anyway the AS5600 with Flowcode is perfect, so hereby, share my little testprogam maybe usefull if anybody need a diy servomotor or measure an angel.
Again one of MM team´s very well working component macro (Benj)
https://www.ebay.com/itm/233616919644?_ ... R5D47PasZg
It´s a while I last used this component so a need a test.
I am trying to make a project where I need some kind servomotor, for an automatic gate opener. So I have bougth a couble of AS5600 hall angle sensor and will first test these device with FC.
After make a test setup and managed to fix the small magnet on a shaft and center the PCB over the hall sensor ( have to be stabil and close ) I try create a testprogram, yes it work so nice with FC10 as well in debug as in realworld
I try to change the in the Properties for analog and PWM out, can change it, perfect.
I also try to change the Slow and fast filter and Hysteres, but I don´t see or feel any change, Properly me
Anyway the AS5600 with Flowcode is perfect, so hereby, share my little testprogam maybe usefull if anybody need a diy servomotor or measure an angel.
Again one of MM team´s very well working component macro (Benj)
https://www.ebay.com/itm/233616919644?_ ... R5D47PasZg