Flowcode Support Board

Hello everyone,

I am trying to send data from an ESP8266 to emoncms using Flowcode, but I am not able to get the ClientSendRequest block working correctly.

I have already tried several approaches, but I am still having difficulties with building the HTTP GET request.

Hi

When posting, to try and avoid bots your first few posts need to be approved before appearing. This may initially delay them appearing but is only temporary. I have deleted your duplicated post.

As for your question I am sure it won't be too much trouble to assist (I won't personally be able to assist until next week). It would be helpful if you would post your chart and any details of how your target want to receive the data.

I use the 8266's as a goto and find them very easy to implement. Usually though I control them directly using "At" commands.

If you search this and the old forum for esp8266 there is a ton of information.

Regards