Flowcode Support Board

Hello,

Una duda antes de comprar estos modulos Ky-022 Sensor Receptor Infrarrojo Ir Pic, funcionan a 38 khz con un pulse time de 940, veo en propiedades del componente RC5 que se puede cambiar la frecuencia de 36 khz a 38 khz y el pulse time tambien puede cambiarse a 940, busque en el Foro el modulo pero no hay informacion, alguien me podria informar para saber si puedo comprar estos modulos con la confiansa de que los acepte Flowcode 10 o Flowcode 11 para programarse correctamente

Thanks
Best Regards
Enrique

I'm sure it should be possible to get it to work - it just outputs pulses - and rc5 (and other IR remote) format is fairly easy to decide..

See viewtopic.php?t=1120&hilit=Rc5 for a discussion...

Martin

Hello Martin,

Por lo visto las propiedades del componente han cambiado del 2020 a 2026, si se puede cambiar las propiedades, pero si funcionara para comprar unas cuantos modulos

Enrique
Aprecio tu comentario

I've not tested the new version...

I'm not sure how the IR frequency affects the results - as long as the sensor is correct (maybe some are tunable?)

Worth a try?

Hi,

Okay, thanks. I think I'll order 10 pieces. The taxes are more expensive than the component itself but I'll see if it's compatible with Flowcode 10 or Flowcode 11. I don't have the knowledge to create the component myself. (And it takes 10 days to arrive)

P.D. Medelec, Ben, hello, I think you're busy, but do you, as the creators of Flowcode 10 and 11, know if the component can be adjusted in the program's properties

Regards
Enrique

Hello

I started programming TX for now, but when I compile it, I get an error. It shows the same thing in Flowcode 10 and Flowcode 11.

I selected the three timers (Timer0, Timer1, and Timer2) in the properties, and I didn't change the original frequency or pulse time.

I think it's a bug.

Enrique
Thanks

Hello

I swapped the chip to the PIC16F1847 and it compiled fine. Then I switched back to the PIC12F1840 and the error was fixed; it compiled correctly. It only displayed a warning.

Hi

I apologize, it might seem like I'm just playing around, but I'm not. I took the published example and made some changes, and it compiles correctly, with two warnings, but it finishes compiling. Now, in a program I've put together, I added the RC5 component, and it again shows an error when compiling. This is the message it displays. Could you check it to see if it's a bug in Flowcode 10 or if I've made a mistake

Enrique

This is the rest of the compilation error.

Please could you attach your flowchart - saves us re-entering it..

If you use 'full editor and preview ' attachments are just below the edit box (or you can drag and drop the file onto the edit box)

Martin