Page 1 of 1
ESP tool chain not installed!
Posted: Tue Dec 15, 2020 3:58 pm
by jgu1
Hi!
Just received my ESP 32 and want to test. After install the toolchain I try to compile to chip, I get the message "ESP toolchain not installed is there some special I have to do?
Br jorgen
Re: ESP tool chain not installed!
Posted: Tue Dec 15, 2020 4:22 pm
by LeighM
Did you follow all the instructions in the link below, carefully
... including the Flowcode Global setting?
https://flowcode.co.uk/wiki/index.php?t ... Toolchains
Re: ESP tool chain not installed!
Posted: Tue Dec 15, 2020 5:02 pm
by jgu1
Tryed again, and yes, I have forgot the location in global setting, sorry. Now it begin to compile, but will not program the ESP32
Re: ESP tool chain not installed!
Posted: Tue Dec 15, 2020 10:32 pm
by LeighM
You also need to set the COM programming port, see this post ..
viewtopic.php?p=57#p57
Some ESP modules also need the BOOT switch pressed when programming.
Re: ESP tool chain not installed!
Posted: Wed Dec 16, 2020 4:03 pm
by jgu1
Hi LEigh!
Your suggest already tryed. I cannot see any comport in the settings , no matter what I do. I hear the pling when I connect the USB and see Com17 when I att the USB in devicemanager
Re: ESP tool chain not installed!
Posted: Thu Dec 17, 2020 8:51 pm
by jgu1
Hi Leigh!
What can I do please
Br
Jorgen
Re: ESP tool chain not installed!
Posted: Thu Dec 17, 2020 9:20 pm
by LeighM
Have you selected COM17 as the programmer port on the Project Options screen?
This works similar to the port for Arduino programming.
Re: ESP tool chain not installed!
Posted: Fri Dec 18, 2020 3:59 pm
by jgu1
Hello Leigh!
Ok, well, could not find it in the manual
Now I can compile. Thank you.
Br Jorgen