Flowcode Support Board

Hello to everybody,

I am a fan of the Flowcode Softwares, but I have a problem.
Actually, I am in the trial period of Flowcode 9.
I am trying to transfert the Flowcode program to Raspberries.
When I will to build and to compile to the chip (Raspberry), there is a message saying me that the connection is not done.
In the "New Project" phase, I have introduced the IP, but without succes.
So, is there anybody to explain me the right procedure to follow?
I have also followed the tutorial of Matrix, but this one is a few short in its explinations...

I thank you for your reply and,

Best regards.

Michel.

Yes, things to check are:
The IP address of the Pi, and login name and password, set in project config screen.
The Pi and PC need to be on same network/router.
SSH enabled on the Pi, see Raspi-config (as I recall)

I thank you very much for your reply.
Tm
Tomorrow, I shall try your advices.

I shall write to you back as soon as possible.

Best regards.

Michel.

If you are still stuck after following this tutorial, then I will follow the tutorial to see if it sends a program to the Pi.