Matrix user forums

Hi Jonny

Many thanks for this information.
Yes you are right, this was the problem.

great and fast responce!!!
Thanks to all!!


best regards
Christian

Hi Ben

Thanks for the File.
It is the same i have installed.
My Version is V5.1.0.0 (10.02)

@Steve
I have nothing change on our code.

I have write a short test.
Same Error.

Hello

I have open a V4 Project in V5.
All looks fine.
When I build the hex File I found in the compiler messages box
this Information:

Warning: function never returns: 'FCD_SWITCH0_ReadState'
Warning: function nev
........

er returns: 'FCD_SWITCH1_ReadState'
Warning: function never returns: 'FCD ...

Hi Ben

Thanks for your Infos.
I have change follows in "PIC_SPI_Legacy.c"
All sspstat, sspcon sspcon1 and sspbuf to ssp2stat, ssp2con, ssp2con1 and ssp2buf.
Hope this is right.
OK, how I can now define my port D4 D5 D6 and as Enable H0,H1 or H2?
I am not shure where or with witch command you choose ...

Hello

In my actually project PIC18F87J11 with Flowcode V4.3.7.63 I need I2C and SPI.
SSP port 1 should be configured as an I2C port, one external EEPROM and RTC are connected to it.
SSP port 2 should be configured as a SPI port, one external Flash and SRAM and one FTDI V2dip1 are connected to it ...

Hi Benj

Many thanks for your replay and the fcd file.
The HiTech C compiler is already installed on my system.
I have install it with your Howto. It works.

Only one problem with the HiTech compiler.
When I compile my work to hex File all is right but
no information about the configurations words ...

Hello

I work with the latest Version Flowcode 4.3.7.63
All is fine - Great work!!
For my new Project I have chosen the SBC83i Board with PIC 18F87J11.
http://www.modtronix.com/product_info.php?products_id=406

I am not so deep inside programming Pic, and so I am not be able to write a new fcd file ...