Matrix user forums

Thank you for the advice :P

Just to clarify the need to "run as adminstrator" .... it really comes down to Flowcode overide statement:
C:\Program Files\Matrix Multimedia\Flowcode V3\ECIOprog.exe -nogui "Flowcode1.hex"

What appears to be happening is that once "compile to chip" has been selected ...

Thank you .... I'm getting much further I think.

Having set the target to ECIO-28 (instead of the chip used), Flowcode complained over the configuration. I realised that UAC was stopping the process copying the compiled program (in my case "Flowcode1.hex") into a Program Files area (protected by ...

Thanks Ben for your assistance with this.

The messages I get with ECIOProg.exe (starting it just before plugging in the ECIO) are as follows:

ECIO not found!
ECIO-28 version: 1.1
Ready

The LED does remain flashing and I assume from the messages above, that the ECIOProg does at least recognise the ...

Thanks for your post Damian; sorry to hear that you have the same problem. I have also now tried it on my old laptop with XP plus sp3 installed ... but very same problem

I'm using Vista (Home edition) and Flowcode claims ECIO-28P (USB) not connected: "USB Cable not plugged in, Continue?".
:cry:
Searching for an answer on this, I understand that Vista powers the module up and immediately powers it down, so I only see it listed in Device Manager for a fraction of a ...