Matrix user forums

Hello Ben,

thank you very much for your quick and detailed answer. I've changed the configuration settings in "expert config screen" according to your suggestions, see the attached screenshot.
I don't understand your suggestion about connecting an additional (?) USB connector to PORTC of my ...

Hello all,

I've installed the flowcode 3.0 usb_pack as I'd like to control my PIC18F2550 by LabVIEW. The PIC18F2550 is suggested in the demo presentation of the usb_pack. Unfortunately the flowcode example "USB Slave Demo 3-Byte" of the usb_pack is for the PIC18F4455. After deleting "Output byte2 ...

Hello Ben,

thank you very much for your advice and the modified ppp_config_data3 file.

Meanwhile I've found in the datasheet of the PIC18F2550 that you've to configure the PIN RB5/KBI1/PGM as LVP.

After installing your modified ppp_config_data3 and setting the LVP jumpers in the following way ...

Hello

Please replace the file in your C:\Program Files\Matrix Multimedia\Common\PPPv3\ directory with file from inside the attached archive.

The chip should auto detect when in the expert mode of the PPP / Flowcode configuration. If it does not autodetect then are you powering the board with a ...

Hello,

as English is not my native language the description of my problem is not fluent. I do hope you're understanding anyway and give me its solution. :roll:

I've programmed the PIC16F88 which is normally plugged in the MCU-Multiprogrammer EB-006-00-6 with "Flowcode V3" successful. The ...