it's so difficult to find out what PIC you need

[rene]

I have been searching on several sites, i give up now.

I'm looking for a Pic with a 12bit ADC, internal ref + and an internal clock.
Memory and speed not really matter, must be supported by Flowcode v5

Is there a more simple tool than Microchip product selector, so you can see whether it is supported by FC.
First you need a lot of effort to make a selection, to find out later the chip is not supported in FC

[Enamul]

Hi
I guess you already tried PIC18f1936 but did you tried 18F14K50. This also has the feature you are looking for.

[Steve001]

martin (medelec) found a good selector tool and easy to use too, not got much time a min to find it i am sure people on here will point you in the right direction or if you ask him


steve

[Enamul]

Steve is talking about the following post of Martin..
http://www.matrixmultimedia.com/mmforum ... 370#p36370

[Enamul]

This one is also helpful..for general selection not for 12-bit adc and internal Vref..I guess that can only be done by Goggling.
http://www.microchip.com/ParamChartSear ... &pageId=74