AVR Crash - Resolved

[JohnCrow]

When I try to save an AVR flowchart (Any device)
I get the following message

AVR_Crash.jpg (28.92 KiB) Viewed 9240 times

It seems to save the file, but if I try to open it I get the messge

Failed to open document
Attribute <Data> is not found

Arduinos will save though.

[dazz]

Hi John
seems to save and open fine on my system (device) attached was one i did after your post to check (attached)
Regards
Dazz

avr save test.fcfx

(7.58 KiB) Downloaded 357 times

[JonnyW]

Hi John.

Is there anything you add to the project, or can you create a completely blank project and get this message (I notice there are some component calls in the background).

Can you post a corrupted file - whereabouts in the file it fell down may give a clue as to what is happening (though its a long shot).

Jonny

[JohnCrow]

Hi Jonny
I put one in my other post yesterday about not been able to compile other devices
At work at the moment. Will try a blank project tonight

[JohnCrow]

Hi Jonny
Tried saving a blank flowchart, get the same results.

AVR_Crash.zip

(23.86 KiB) Downloaded 343 times

[JonnyW]

Excellent, thats caught it I think. There was a problem storing the config data - I think that will have fixed a couple of other strange config storage issues too.

Should be fixed in the next release.

Jonny