Clock speed in project options

[Jan Lichtenbelt]

I use the internal oscillator of 16 or 32 MHz. In the project options these frequencies are not in the list of possible frequencies. If I use e.g the RS232 hardware, the baudrate depends on the choice of the frequency in this list.

Is there a possibility to get a baud rate of eg 4800 with an internal frequency of 16 MHz?

Kind regards

Jan Lichtenbelt

[Benj]

Hi Jan,

You can type your clock speed value in directly via the project options window allowing any value to be entered which is less then or equal to the maximum clock speed for the device.

ProjOpts.jpg (47.86 KiB) Viewed 2124 times