Matrix user forums

Hello,

I'm trying to connect my flowkit to an ECIO-40, which is inserted into a EB061 board.
I have selected Port E, since I have CAN and RF modules connected to port B.

When I select "Go/continue" in the Debug window I get "ICD has failed to communicate with the target".
The LEDs on the Flowkit are flashing slowly.
I have attached a file with the ICD settings.
My Flowcode version is 5.4.

Are there any other settings I need to make?
What I can understand from the manual the ICD is active, but the microcontroller is inpause. how can I start the controller?

Regards
Erik

Hi
I have moved the topic to general programming as it's not a tip or trick. Thanks Jac

Are you using external power?

See http://www.matrixmultimedia.com/mmforum ... 253#p20253

Hi,

I'm using external power to the board.