Page 1 of 1
Is the AVR Dragon Programmer Supported?
Posted: Wed Jan 30, 2013 5:27 pm
by ngmflowcode
Is the AVR Dragon Programmer and ICD supported?
-NGM
Re: Is the AVR Dragon Programmer Supported?
Posted: Wed Jan 30, 2013 6:14 pm
by medelec35
Please do not post multiple posts on the same topic.
I have deleted your other post asking the same question.
Thank you
Re: Is the AVR Dragon Programmer Supported?
Posted: Wed Jan 30, 2013 6:20 pm
by ngmflowcode
I apologize, it was an issue with the refresh in my browser.
-NGM
Re: Is the AVR Dragon Programmer Supported?
Posted: Wed Jan 30, 2013 7:24 pm
by dazz
Hi
It should work, im kinda busy so if you can find a list of command line parameters, and the command line programmer software and post a link i will see if i can figure it out for you, another option is to compile to hex in flowcode then program the hex using avr studio
Regards
Dazz
Re: Is the AVR Dragon Programmer Supported?
Posted: Wed Feb 13, 2013 8:42 pm
by ngmflowcode
There are some examples on this page, not sure if it is enough.
http://support.atmel.com/bin/customer.e ... try&id=686
Despite being in the free forum, we now own a full AVR Flow Code 5 version license.
-NGM
Re: Is the AVR Dragon Programmer Supported?
Posted: Wed Feb 13, 2013 9:14 pm
by dazz
Hi ngm
I will have a look when i've got a spare few minutes, can you sigh=n up to the V5 forum using the link in my sig
Regards
Dazz
Re: Is the AVR Dragon Programmer Supported?
Posted: Wed Feb 13, 2013 9:55 pm
by dazz
Hi
I dont have a dragon but try the programmer setting in your config see image below, this assumes you have the avr dragon command line tool installed, you may have to change the location to suit your pc
Regards
Dazz
- Try.jpg (62.47 KiB) Viewed 4990 times