Matrix user forums

Hi,

So I have received the ICD FlowKit and decided to test it. Simple program to count upwards a float variable in a while loop. I set it up as by default to B port and pins 7 and 8. Compile it, after downloading program to the chip, I switch over the switch from PROG to ICD, and then press PLAY in flowcode...soon after a message popes up saying:

[img][/img]

I press YES and:

[img][/img]

Any Ideas what is wrong? Recompiling does not help...

Cheers,
Mantas

HI
I haven't got any matrix boards but have you enabled icd in the build/project options/ icd options tab ,then send the program too chip

Regards
Dazz

Hello Dazz,

Yes I did. I followed the instructions in the manual...

Cheers,
Mantas

So I worked out, what was causing this problem...the problem was, that the switch over from PROG to ICD was causing some issues. Now I have connected two separate USB cables to different USB ports, and the switch is always left on ICD, so as soon the program is downloaded to the chip it starts working in ICD mode, but the variable watch is still an issue, all variables are 0.00000...still investigating.

Cheers,
Mantas

I have read some post in the forum, and found out that there should be *.cof file generated, is it also true for ARMS? Cause I can not find such file generated...

Hello MM,

So will anyone answer me about the COFF file?

Regards,
Mantas