Matrix user forums

Hi,

I am working on a project for positioning a dc motor but when I run the simulation after so long I get a memory error message and Flowcode closes
does anybody have any idea what could be causing this, I suspect it may be something to do with the Eeprom module, I am enclosing a pic of the
message...
Thanks
Acestu

i think it might be a computer registry error, try doing a reg scan, sometimes my computer does this but when it happens to me if i was working on anything on the flowchart i loose it , i never know when its gonna happen so if im working on something hefty i usually save before i simulate just in case, to note it hasn't happened to me in a while

Hi Brandon,

Thanks for the info, I will have a look at the registry when I get home....

Cheers
Acestu