Page 1 of 1

PPP V3 detects incorrect PIC Micro

Posted: Tue Jun 04, 2013 9:48 pm
by Carmen Garcia
Hello everybody:
1
I have inserted my new MicroChip PIC16F877A in my new Multiprogrammer Board and when I tried to test the board, the PPP V3 "Autodetect Chip" says the PIC micro is "F1674"¡¡

I mounted other new PICmicro in other Multiprogrammer and the same respond¡¡¡

Multiprogrammer Board, EB-006-00-8
J11 => PSU
XTAL + SLOW Mode
J18/J19 => OSC

I'm very nervious...

Thanks you very much
Regards

Re: PPP V3 detects incorrect PIC Micro

Posted: Wed Jun 05, 2013 9:38 am
by Carmen Garcia
Hello everybody:

Please, if anybody knows about this issue, share with me.


Thanks you very much.

Re: PPP V3 detects incorrect PIC Micro

Posted: Wed Jun 05, 2013 12:13 pm
by dazz
Hi Carmen
a few things to check have you removed the pic that comes with the matrix board(can only prog one chip not two or more)
If your using win8 disable driver signing reinstall ppp run as administrator

Regasrds
Dazz

Re: PPP V3 detects incorrect PIC Micro

Posted: Wed Jun 05, 2013 12:24 pm
by Carmen Garcia
Thank you very much Dazz for the reply.

The board haven't a PIC, this comes apart from the board, and this is the unique PIC that I have.
My windows is Win 7 Ultimate.

I don't know disable driver signing....Please, could you indicate me how to?

Thanks you very much Dazz
Best Regards

Re: PPP V3 detects incorrect PIC Micro

Posted: Wed Jun 05, 2013 3:39 pm
by dazz
Hi Carmen
It's only win 8 that needs disabling win 7 should be fine,make sure no e blocks are plugged into the programmer and try again, when you plug the board in does it show in device manager, if it does try reinstalling the software and reboot pc

Regards
Dazz