Console - RS232
Posted: Sat Aug 17, 2013 11:12 am
Remove Tx:
This will make it much better especially if you have different variables being printed next to each other say separated by a space.
TX can be left in UART com port section.
If the console is used for viewing transmitting and receiving RS232 chars, then just have tx as one colour e.g red, and Rx as another colour e.g blue. The arrows on the graphics for RS232 and text of console could match. so when red arrow of RS232 component is lit, then the font of in console that represents tx will also be in red.
This will make it much better especially if you have different variables being printed next to each other say separated by a space.
TX can be left in UART com port section.
If the console is used for viewing transmitting and receiving RS232 chars, then just have tx as one colour e.g red, and Rx as another colour e.g blue. The arrows on the graphics for RS232 and text of console could match. so when red arrow of RS232 component is lit, then the font of in console that represents tx will also be in red.