Page 1 of 1
Add abort option to "Pins not connected" warning
Posted: Sun Aug 25, 2013 2:28 pm
by kersing
When compiling the warning about unconnected pins does not allow to abort. This is not a problem for small programs, but for large ones code generation can take a considerable time (when using large LUTs).
Please add the option to abort compilation when the warning is displayed.
Re: Add abort option to "Pins not connected" warning
Posted: Mon Aug 26, 2013 7:27 am
by Mantas
Or option to disable pins unconnected warning, like for CAN component when you are not using DAC and NV pins.
Re: Add abort option to "Pins not connected" warning
Posted: Mon Aug 26, 2013 9:38 am
by kersing
Mantas/Martin,
See
this message for a solution to turn the warning off.
For this feature I want it enabled, but if I make the mistake to have unconnected pins I want to be able to abort compilation. One of my flowcharts takes 3 minutes to translate to C code and I don not enjoy waiting for it when I know it needs to be redone after connecting the pins.
Regards,
Jac
Re: Add abort option to "Pins not connected" warning
Posted: Mon Aug 26, 2013 10:04 am
by medelec35
kersing wrote:One of my flowcharts takes 3 minutes to translate to C
Oh I understand.
When I read the post and thought huh? For hex code generation there is a cancel button.
But you mean with C, as with C there is not.
So yes, I do agree with you Jac.
There should be an option to cancel.
Never noticed before as I don't compile to C that often.
I will remove my post and add a new request feature.
Martin