Matrix user forums

Does Flowcode support ECCP modules for Microchip controllers or plans to do so? I've seen posts on this forum from people in the past regarding this. I would like to request this if possible. Thanks.

Hello,

Thanks for your request, Do you have any specific devices or functionality in mind?

I'm trying to work with a 18f87k22 chip. I'm wanting to drive (5) 5V dc motors independently. Maybe I can do this with the standard ccp modules? I'm new to this and still figuring out how to do this.
Thanks for your reply.

After reading the datasheet for the chip, I think I could use the half-bridge driver mode with the programmable dead band delay feature. I could use the auto shutdown and auto restart features and special event trigger. There are some other feature like programmable polarity and output steering mode but I don't think I could use those.

Thanks

hi,
i am also looking for the same.
i m going to use the controller 16f1936, which is equipped with enhanced pwm, where dead band delay also included.
i just want to know that how those some enhanced features used or controlled through FC4.

thanks n regards
Prashant Kamble.

hi,
rocket6delta, anybody got the idea...?