Matrix user forums

Dear,

Have you an example of Miac USB Slave? (Software and hardware)

Best regards

Nazaire

The MIAC USB slave component is an interface to allow you to control the MIAC from the PC using the USB connection.

To start you have to load the MIAC with the USB slave firmware. The pre-compiled firmware can be found in the attachment below. Use the MIACprog.exe tool to load the hex file onto the MIAC.

MIAC USB Slave - Firmware and v5 Source Once you have programmed the MIAC with the firmware and installed the USB driver the MIAC USB Slave component should be able to see the MIAC. Next with the MIAC USB Slave component added to your program in v6 switch to the correct instance by changing the MIAC USB Slave instance property.

Flowcode v6 MIAC USB Example Running the simulation should toggle transistor output 1 on the connected MIAC. Make sure you have connected VMot to VPsu to allow the output to supply current to the LED.

Let me know how you get on.

Thank you Benj

The Miac USB slave work now perfect

Best regards

Nazaire