Page 1 of 1
about ecio40 serial interface
Posted: Wed Feb 19, 2014 7:29 pm
by ALOPEZ
hello, I'm trying to config serial interface with flowcode 6, but i can't find were you can chose baudrate. I guess that is standard 9600.
somebody link with labview 2013?
thanks.
Re: about ecio40 serial interface
Posted: Wed Feb 19, 2014 10:37 pm
by medelec35
Hi ALOPEZ,
With Flowcode V6, after adding the RS232 component, all you do is right click on the component on your 3D System or 2D DashPanel and select properties.
Like with the majority of other components will allow you to choose different settings.
E,g in this component software and hardware mode, baud rate etc.
Sorry not sure about Labview.
Re: about ecio40 serial interface
Posted: Thu Feb 20, 2014 2:53 pm
by ALOPEZ
Hello,
I dind't explain right,i mean with usb serial mode,how you select the baude rate?
Re: about ecio40 serial interface
Posted: Thu Feb 20, 2014 4:26 pm
by medelec35
Ah Sorry,
I thought you meant RS232, and when you stated 9600 I put 2 + 2 together and made 5.
Martin