Matrix user forums

Good morning guys.
I am with a new project monitoring electrical equipment at home with a microchip circuit mcp39f501.
This communicates via SSI (Simple Sensor Interface) but I can not send or receive data through rs232.
Anyone know how to help to communicate by UART. I've been trying to communicate in various ways and have no answer for a week. I do not know what I'm doing wrong.

In datasheet "The default baud rate is 4.8kbps. The UART operates in 8-bit mode, plus one start bit and one stop bit, for a total of 10 bits per byte."

Many thank you very much.

Hello,

The RS232 component interfaces the UART and sends out the 10-bit packets as you described. Can you attach your program so we can see what you've tried so far.

Hello again Benj.

It's the first time I use UART, I need to send a data frame for the MCP39f501 respond.

The development board is that I have to send frame and the IC responds.

I think the problem is not like sending a frame by uart and then not know how to configure the RS232 macro to send, received and save data.

For testing I'm using a 16lf1939.

thanks

Hello,
I'm trying to capture the frame the software returns IC microchip.
This is the program I'm doing wrong?
thanks

Hello guys.
I've been doing more tests and only get the first record read "header byte" = 6, it´s ok but the rest gives me random values.
Has anyone managed to get a complete frame in RS232?, Could you help me?
thanks

Hey guys.
I've been doing this weekend many tests. Now I get to read all the data frame correctly.
I look forward to this part of the program list shortly.

A greeting and thanks