GLCD with SSD1306 not working
Posted: Sat Oct 25, 2014 6:02 pm
I baught an oled display with the chip DSS1306 in spi-mode. After init and placing a number and a line occurs the following:
The number are only lines in a block.
The line is presented in several lines
All lines are displayed with one line spaceing?
In the forum where an older component file, which I tried and the result was a black display.
So have anyone an idea to resolve this situation?
All needed infos are placed on the attached jpg.
The number are only lines in a block.
The line is presented in several lines
All lines are displayed with one line spaceing?
In the forum where an older component file, which I tried and the result was a black display.
So have anyone an idea to resolve this situation?
All needed infos are placed on the attached jpg.