Graphical bugs
Posted: Sun Nov 15, 2015 12:15 pm
Hello!
Is it possible to turn off the smoothing on LCD ang gLCD? It's buggy in the simulation while in the HW looks good. Hard to debug in the simulator.
Not possible to rearrange the components in the Project explorer window. If i want to see the gLCD (default, all the components is expanded to see it's macros), i always have to scroll down, because i added it to the project later then the three swithes (wich is never used).
Opening a project, the component "Switch (Generic)" always in active state. Operation: Momentary.
Console tabs: switching between the tabs, the activated tab always scroll down to the bottom. It's not rememebers to the last position.
In the project window, where is the flowcharts, mouse scroll speed depends on the lenght of the flowchart. If a flowchart is long, the scroll wheel unusuable. Looks like the same, when you hit the PageDown two/three times.
Is it possible to turn off the smoothing on LCD ang gLCD? It's buggy in the simulation while in the HW looks good. Hard to debug in the simulator.
- Graphical-bug1.jpg (29.63 KiB) Viewed 4783 times
- Graphical-bug2.jpg (35.33 KiB) Viewed 4783 times
- Project Explorer.jpg (31.29 KiB) Viewed 4783 times
Console tabs: switching between the tabs, the activated tab always scroll down to the bottom. It's not rememebers to the last position.
In the project window, where is the flowcharts, mouse scroll speed depends on the lenght of the flowchart. If a flowchart is long, the scroll wheel unusuable. Looks like the same, when you hit the PageDown two/three times.