Matrix user forums

hi,
i am planning to implement capacitive touch sensing using only ADC pin.
anybody has done this?
how can i implement this in flowcode?

Hello,

In Flowcode 6 and 7 there are components (touch pads / touch slider) to allow you to do this.

There's also loads of info already on the forums about how to create your own cap touch code. Just use the search feature and use the keywords cap touch.

HELLO BEN,

as per your suggestion, i went through a search with keyword CAP TOUCH and i found a thread where you only have mentioned that in FC5 there is a option called 'ADC raw'.
i would like to know how that works for cap touch. or do you have any example that uses adc raw feature?


thanks and Regards,
Prashant

prasha920 wrote:HELLO BEN,

as per your suggestion, i went through a search with keyword CAP TOUCH and i found a thread where you only have mentioned that in FC5 there is a option called 'ADC raw'.
i would like to know how that works for cap touch. or do you have any example that uses adc raw feature?


thanks and Regards,
Prashant

Hi Prashant, any luck getting Ccap touch to work?

Hi Guys,
Have you seen this thread?
If you scroll down on the thread there are more examples.

Martin

hey Martin,
thanks a lot... was waiting for your reply too.. ...
ok, i check the link and come back...
once again thanks..

regards,
Prashant

hi Spilled,
i'm sorry for late reply..
as i didn't had much time to work upon those examples, i couldn't tried it.
as soon as i work on those examples with hardware, surely will update you guys..
thanks and regards,
Prashant

Thanks Prashant,
Good luck with the testing.

Martin