Matrix user forums

Hello

My program can light up an LED in the rhythm of 1 second. Unfortunately, the real clock rate of my LED is only 0.67 Hz (measured with the oscilloscope)

Prozessor: 32MX320F128h
Microcontroler clock is 120000000 Hz

Unfortunately I can make any configurations. What should I do so that my ChipKit UNO 32 runs with the right frequency.

can someone help me

Hello,

If you get rid of the UART transmit string then does the LED output at the correct rate? It could be we have the default clock rate of 120MHz set incorrectly for the Uno32 bootloader.

You cannot edit the configurations because they are set for you by the bootloader. Forcing the configuration in will cause the programming to fail as it's outside the bootloader's memory bounds.

Hello,

Thank you for the answer.

My next question is, wath should I do that the programm runs???

Pascal_2016 wrote:Hello,

Thank you for the answer.
My next question is, wath should I do that the programm runs???

Do as Ben suggested and report back here that if there is a bug MATRIX can fix the bug and you also have no problem any longer or use a PICKIT 3 and program your board with the PICKIT3 however then you have to make your own confifurations for the chip