Matrix user forums

Hi everybody!

A technical question about Flowcode7 and I2C master component.
I have a slave device with just one byte internal address.
The question: How can I work with Rx or Tx ByteTransaction macro when I haven't 2 byte internal address?
If I leave blank the AddrH or AddrL line, it makes an error massage.

Has anyone a solution for this problem?

Thanks!

Rather than using the Transactions, you will need to build up your own protocol, to match what the device requires,
such as Start, TransmitByte, Restart, ReceiveByte, Stop

Have you tried this on hardware?

I have had experience in which the slave device ignores the hi byte addr - it work by setting the addr 0

just a thought it possibly hardware dependent?

petesmart wrote:Have you tried this on hardware?

I have had experience in which the slave device ignores the hi byte addr - it work by setting the addr 0

just a thought it possibly hardware dependent?

Thanks, I will try it....

LeighM wrote:Rather than using the Transactions, you will need to build up your own protocol, to match what the device requires,
such as Start, TransmitByte, Restart, ReceiveByte, Stop

Hi, yes I usually use this method what you wrote. I have asked, because maybe there is a comfortable solution. Thanks!