Matrix user forums

Posted: **Tue May 30, 2017 3:34 pm**

Hi Ben,

I am using a 32MX270F256B and when using the CAL UART, if the baud rate is updated the comms will stop. If the update baud icon is disabled the comms works fine. I have attached the test program that i have been using.

I have also installed the patches you have created that takes care of all the timing and peripheral issues too.

Thanks

Zane

Posted: **Tue Jun 06, 2017 9:58 am**

Hi Zane,
Could you please try the attached CAL file?
Thanks
Leigh

PIC32BIT_CAL_UART.c: (22.18 KiB) Downloaded 517 times

Posted: **Thu Jun 08, 2017 7:28 am**

Hi Leigh,

I have tried this but it has not been successful.

Thanks Zane

Posted: **Thu Jun 08, 2017 8:17 am**

OK. Thanks for testing. I'll stick this PIC32 issue on Ben's pile

Posted: **Tue Jun 13, 2017 10:47 am**

Thanks for letting us know of the problem.

I have replicated it and have found a fix.

Simply copy the attached file into your "Flowcode 7/CAL/PIC32BIT" folder and the problem should be resolved.

PIC32BIT_CAL_UART.c: (22.11 KiB) Downloaded 568 times

Let us know how you get on.

Posted: **Wed Jun 14, 2017 10:59 am**

Hi Ben,

Thanks for the update i will try it later on this week.

Thanks

Zane

Posted: **Thu Jun 15, 2017 11:25 pm**

Thanks Ben, your magic worked a treat, it is functioning as expected now

Matrix user forums

CAL UART comms stops if the baud rate is updated

CAL UART comms stops if the baud rate is updated

Re: CAL UART comms stops if the baud rate is updated

Re: CAL UART comms stops if the baud rate is updated

Re: CAL UART comms stops if the baud rate is updated

Re: CAL UART comms stops if the baud rate is updated

Re: CAL UART comms stops if the baud rate is updated

Re: CAL UART comms stops if the baud rate is updated