Control Lathe
Posted: Wed Aug 02, 2017 5:17 pm
Good morning
I have a small lathe I would like to control
Via Arduino board, A4988 driver and NEMA17 engines
Since I have to do simple work (go back one piece or lower it)
I thought as a display to use a nextion model nx4832t035_011
From this I would set the turning values and the percentage
As well as the speed of movement and how much material to remove for each pass
My biggest problem and how to handle the driver Step and DIR commands
Through flowcode so you can also control accelerations.
Can anyone help me with some lines to follow?
I'm sorry x my english translated through google
I have a small lathe I would like to control
Via Arduino board, A4988 driver and NEMA17 engines
Since I have to do simple work (go back one piece or lower it)
I thought as a display to use a nextion model nx4832t035_011
From this I would set the turning values and the percentage
As well as the speed of movement and how much material to remove for each pass
My biggest problem and how to handle the driver Step and DIR commands
Through flowcode so you can also control accelerations.
Can anyone help me with some lines to follow?
I'm sorry x my english translated through google