Page 1 of 1
Compilation error?
Posted: Sat Nov 25, 2017 6:55 pm
by Osta
The display has connected 7 segments.
At emulation reports about a mistake
Re: Compilation error?
Posted: Sat Nov 25, 2017 7:03 pm
by Osta
Osta wrote:The display has connected 7 segments.
At emulation reports about a mistake
Re: Compilation error?
Posted: Sun Nov 26, 2017 2:52 am
by medelec35
As you have common pins 2 & 3 unconnected, flowchart will not compile.
You need to connect common pins 2 and 3.
If you only have x2 7seg displays instead of x4, then you need to use 7Segment(Single) instead of 7Segment(Quad).
If you can't find it then select search and enter 7seg
Martin
Re: Compilation error?
Posted: Sun Nov 26, 2017 9:31 am
by Osta
Hi Martin!!!
Thanks for explanation.
I have so thought too... To make such decision
i was forced by an opportunity in
settings the mode - "aren't included".
I have made just as you have told and everything works!!!
Control "isn't included" to me it is unclear...
Osta