Matrix user forums

Hi all.
So I`ve been trying to use the I2C Eeprom component without any success, has anybody else used it since upgrade 7.3?
It compilates ok, but when running the program it stops in the Read command.
The MCU speed seems ok after running the "blinker test" at several rates and also PWM channels runns at calculated speed.
Target is: 24EP512GU810@140Mhz

Annybody got a clue?

electronix.

Hi,
Could you just check that the channel and port properties are correct in your project for the eeprom component?
There is a chance that the defaults have changed.
If it still fails, could you change to the "Software" channel and see if that works.

Hi Leigh.

I just did the last upgrade of 7.3 and after some testing it seems to work in both HW and SW mode, so I guess its working, I will use it in a project later on though for proper testing.

Thanks a lot