Matrix user forums

Hi Ben

What about a very small BT Modul add to FC8?

Bluetooth Modul (RN4870) RN4871


There is
- P-Mod Modul Digilent
- clickerboard
- Lot of infos
- It is in the Altium Designer avaible


Features
• Fully Qualified Bluetooth® Low Energy Module
• Certified to FCC, IC, CE, KCC, NCC and SRRC
• On-Board Bluetooth 4.2 Low Energy Stack
• ASCII Command Interface API over UART
• Compact Form Factor – The RN4870/71 family
- RN4870: 12 mm x 22 mm
- RN4871: 9 mm x 11.5 mm
• UART Transparent Service for Serial Data Applications
• Remote Configuration Over The Air

https://store.digilentinc.com/pmod-ble- ... interface/ clickerboard https://www.mikroe.com/rn4871-click

some more infos
https://www.mouser.ch/new/microchip/mic ... 70-rn4871/

Did you know about this one, based on RN4677?
https://www.matrixtsl.com/webshop/e-blo ... board.html

Hi Leigh

Thank you for the info. The Modul RN4677 I know and it's in my selection too.
The RN4677 modul support the SPP profile.
Hhhmmm it's double size of the RN4871....
But I did not see the module E-blocks2 BL0170. I could build the whole module on my board. I mean I could put the 16Pol plug on my board, then I can also connect other E-blocks2. Is there any info which plug or even an example of the Altium designer?

Hi Team.

I have to support Stephan here it would be great if you can help with the board connector for the Eblocks 2 it will help us
to place these connectors on our boards and plug the eblocks in directly
Type,partnomber and supplies

Hello,

The EB2 connector you are looking for is the Har-flex 16-way connector from Harting. You can get them via RS.
https://uk.rs-online.com/web/p/pcb-sockets/8439052/

The pin out for the EB2 boards can be found in the EB2 datasheet on page 5.
https://www.matrixtsl.com/resources/get ... hp?id=1075

Thanks a million Ben

Hi Ben

Thank you for the Infos. It's easy this way to add some E-block's to an own board.