Page 1 of 1
sensors on ECIO
Posted: Wed Apr 23, 2008 9:55 am
by raghavmonga
how can we connect more than 2 analog sensors on ECIO. is there any E-Block for connecting many sensors to ECIO (except sensor board)
Actually i want to multiplex 9 sensors to the ECIO and want to get there values one at a time.
plz help!!
Re: sensors on ECIO
Posted: Wed Apr 23, 2008 10:44 am
by Steve
You would need to create your own E-Block to do this. Our patch or protoboard E-Blocks are convenient for this.
Re: sensors on ECIO
Posted: Thu Apr 24, 2008 11:47 am
by raghavmonga
sir,
if i have to make my own E-Block, then i would be needing BTA Connectors. Are these supplied separately by matrix multimedia?
Re: sensors on ECIO
Posted: Thu Apr 24, 2008 2:18 pm
by Steve
This part is a bit tricky to get hold of, but we might be able to supply them [although I do not know how much they would cost].
An alternative it to cut the cables of the sensors and connect a better connector onto the end, or solder them directly into your custom board.