Page 1 of 1
ECIO 4OP
Posted: Tue Jan 27, 2009 8:49 pm
by franky
Hi to all!
I have a problem when I try to send a program..
I've done a program whit flowwcode software but when I try to send to ecio 40p the software tell me "send failed"
how can I do?
thanks a lot!
Re: ECIO 4OP
Posted: Wed Jan 28, 2009 9:20 am
by Steve
Hello,
Please give us more details about the problem (exact error message, etc) and we'll try to help.
Re: ECIO 4OP
Posted: Wed Jan 28, 2009 12:46 pm
by franky
i! so..
when I try to use ECIO program I can read the micro, I can erase it and I can reset it, but when I try to send a program I can read the hex file and the software show me that it has charged it, but after that when I select "send file" the software start to send the hex file but then show me "send failed"
I've already try to reinstall the ECIO drivers but nothing change, I tried also to change the micro but I have the same problem.
thanks to all!
Re: ECIO 4OP
Posted: Wed Jan 28, 2009 2:10 pm
by Benj
Hello
What version of Flowcode are you using? It could be that your using the old programming tool. The latest version of the tool can be found here.
http://www.matrixmultimedia.com/software/ECIOprog.zip
Also you may want to switch off the power saving feature of Windows as this is known to cause problems.
http://www.matrixmultimedia.com/support ... .php?t=537
Let us know how you get on.
Re: ECIO 4OP
Posted: Wed Jan 28, 2009 4:34 pm
by franky
Hello!
I'm using Flowcode V3 and I fink that the drivers are the same that you have attached.
thanks a lot!
Re: ECIO 4OP
Posted: Thu Jan 29, 2009 1:15 pm
by Benj
Hello
Did you try the new programnming tool and disabling the power management?
Did they work?
I did not attach drivers!!!
Think is spelt TH
Re: ECIO 4OP
Posted: Thu Jan 29, 2009 2:52 pm
by franky
hello Benj!
I tried whit another pc and it works correctly!...
thank you very much!