Hallo Benj
I found these but if i put in ........-MPIC......... i become on compiler a error 34
----------------------------------------------------------------------------
9. Command Line Options
----------------------------------------------------------------------------
The following commands are available in the command line interface.
PICkit 2 COMMAND LINE HELP
Options Description Default
----------------------------------------------------------------------------
A<value> Set Vdd Device Specific
C Blank Check Device Do not Blank Check
D<file> OS Download None
E Erase Flash Device Do Not Erase
F<file> Hex File Selection None
G<Type><range/path> Read functions None
Type F: = read into hex file,
path = full file path,
range is not used
Types P,E,I,C: = ouput read of Program,
EEPROM, ID and/or Configuration
Memory to the screen. P and E
must be followed by an address
range in the form of x-y where
x is the start address and y is
the end address both in hex,
path is not used
(Serial EEPROM memory is 'P')
I Display Device ID Do Not Display
K Display Hex File Checksum Do Not Display
M<memory region> Program Device Do Not Program
memory regions:
P = Program memory
E = EEPROM
I = ID memory
C = Configuration memory
If no region is entered, the entire
device will be programmed.
(serial EEPROM memory is 'P')
P<part> Part Selection. Example: PIC16f887 None
U<value> Program OSCCAL memory, where: Do Not Program
<value> is a hexidecimal number
representing the OSCCAL value to be
programmed. This may only be used in
conjunction with a programming
operation.
V<value> Vpp override Device Specific
W Externally power target Power from Pk2
Y<memory region> Verify Device Do Not Verify
P = Program memory
E = EEPROM
I = ID memory
C = Configuration memory
If no region is entered, the entire
device will be verified.
(Serial EEPROM memory is 'P')
Z Preserve EEData on Program Do Not Preserve
? Help Screen Not Shown
Each option must be immediately preceeded by a switch, Which can
be either a dash <-> or a slash </> and options must be separated
by a single space.
Example: PK2CMD /1 /PPIC16F887 /Fc:\mycode /M
or
PK2CMD -1 -PPIC16F887 -Fc:\mycode -M
Any option immediately followed by a question mark will invoke
a more detailed description of how to use that option.
Commands and their parameters are not case sensitive. Commands will
be processed according to command order of precedence, not the order
in which they appear on the command line.
Precedence:
-? (first)
-D
-P
-A -F -V -W -X -Z
-C
-U
-E
-M
-Y
-G
-I -K (last)
The program will return an exit code upon completion which will
indicate either successful completion, or describe the reason for
failure. To view the list of exit codes and their descriptions,
type -?E on the command line.
----------------------------------------------------------------------------
Regards Wolfgang
) :