Matrix user forums

Hi,
I am trying to geta LCD display with a KS0073 to work in Flowcode.
It is supposed to be "Near 100% compatible with HD44780" but so far no luck.
The programs works with other HD44780 compatible LCDs that I tried but not with this one.
Does anyone have any experince with the KS0073 and what to change in the LCD macro to get it to work?

The KS0073 has an extra communication mode (serial - looks like SPI). Selection is controlled by an IM input.
Is this line available?
Is it configured for parallel communications?

In parallel mode, the 4-bit bus option required by Flowcode seems to be supported.

The option SPI / 4 or 8 bit databus is controlled with a link on the LCD. It is set to 4 or 8 bit databus mode. The only other thing is that there is a separate pin for a reset line. It has a internal 10k pullup resistor and should not need to be connected if not used.

Data of the display can be found here:
http://www.lcd-module.com/eng/pdf/doma/dip204-4e.pdf

Thanks for your help.

Hello,

In most cases the compatible LCD's should just fire up. Other then that you may have to change the delays or the commands slightly to allow the display to work. Does the display have the normal set of connections? Might be worth comparing the timing information from the datasheets to see if you can spot the difference.

All the normal connections like D0-D7 or D0-D3 in 4 bit mode are there. Also RS and Enable etc.
Where do I change the timing for the LCD componernt i Flowcode?

Hello,

Are you aware when in 4-bit mode the LCD uses the upper nibble of the data bus. Eg the pin marked data 1 in Flowcode should go to the fifth data pin on the LCD etc.

If you have already done this then you will have to use the code customization feature to change the delay timings in the init and rawsend functions.

I tried to implement the following code wich is an example from the display manufacturer into the Custom Code Start macro.

But no luck so faar.

GLOBAL void LcdClr(void)
{
lcdbefout(0x01); // Display l”schen
}

GLOBAL void LcdInit(void)
{
ClrBit(DMRESPORT, DMRES);
waitms(2);
SetBit(DMRESPORT, DMRES);
waitms(50);

lcdbefout(0x34); // Function Set: 8-Bit, Bit RE=1
lcdbefout(0x09); // ext. Function Set: 4 Zeilen Modus
lcdbefout(0x30); // Function Set: 8-Bit, Bit RE=0
lcdbefout(0x0C); // Display On/Off: Display ein, Cursor aus
lcdbefout(0x06); // Entry Mode Set: Cursor Auto-Increment

LcdClr();
}

Any ideas what to do to get this display working?